142 posts tagged with "Misc"

Resetting the DCP-110C Printer Waste Ink Counter is easy, follow the instructions below:

1. Press the Menu & Mono start keys next press the Up arrow key 4 times to make the machine enter the maintenance mode.
2. Enter 8 & 0 by using the up arrow key & SET keys.
3. Press the mono start key several times until the purge count appears on the LCD.
4. Enter 2 7 8 & 3 by using the up arrow key & set keys to reset the purge count to zero
5. Press the stop/exit key to return to the initial stage of the maintenance mode.
6. Enter 9 twice by using the up arrow & set key’s to exit from maintenance mode
7. Restart printer

Trying to print with your HL-140 and the Drum light is on? Follow the instructions below.

Reset the Drum

1. Press the cover release button and then open the front cover of the printer.
2. Press & hold down the Go button until all 4 LEDs are lit. Once all 4 LEDs are lit, release the Go button.
3. Close the front cover.
4. Make sure that the Drum LED is now off.

Caution: Reset the drum counter only when you replaced the drum unit with a new one.

This problem usually occurs due to a Paper Jam in the printer or a faulty Drum unit in the printer. Follow any of the instructions below that matches your problems.

Printing

1. In your word document/or document you are trying to print
2. Go to File
3. Page Setup
4. Paper
5. Make sure that your paper source is set to Tray 1 or what Tray the correct paper is in.

Reinstalling Toner

1. Take off the front cover
2. Pull the tabs on the side
3. Pull out the big toner and cartridge
4. Find the Blue tab
5. Slide the tab from right to left
6. Reinsert toner
7. Close the toner door

If none of the above work, it is possible that your Drum unit is faulty and needs to be sent in to the manufacturer for repair.

1. Remove the switch cover to access the keyboard screws (The switch cover is secured by to screws located in the battery compartment.)
2. Remove the keyboard screws which are located on the top of the system under the switch cover.

1. Click Start
2. Click Control Panel
3. Click on Printers and Faxes
4. Right click on your printer (Canon IP1600)
5. Go down to properties
6. Then click on maintenance
7. Click on ‘View Printer Status…..’
8.  Click on Option
9. Click on enable status monitor (This will turn off the monitor and allow you to use the refilled ink cartridges)
10. If at any time you get the ‘Ink out’ message on your PC a light under your power button on the printer will flash.
11. To **continue printing **press the button and click the close button on the warning (marked X). (You may need to do a few things)